Cisco Cisco ONS 15454 M2 Multiservice Transport Platform (MSTP)
34
Configuring GE_XP, 10GE_XP, GE_XPE, and 10GE_XPE Cards Using PCLI
OL-25022-01
DLP- G650 Configure STCN on the GE_XP, 10GE_XP, GE_XPE, or 10GE_XPE Cards Using PCLI
DLP-G650 Configure STCN on the GE_XP, 10GE_XP, GE_XPE, or 10GE_XPE Cards
Using PCLI
Using PCLI
Step 1
Complete the following tasks, as needed:
Step 6
rep segment id preferred
Example:
MSTP 176# (config-if) rep segment 10
preferred
Configures the edge port as a preferred alternate port.
Step 7
exit
Example:
MSTP-176(config-if)# exit
Exits interface configuration mode.
Stop. You have completed this procedure.
—
Purpose
This procedure explains how to configure segment topology change
notifications (STCNs) on the GE_XP, 10GE_XP, GE_XPE, or 10GE_XPE
cards using PCLI.
notifications (STCNs) on the GE_XP, 10GE_XP, GE_XPE, or 10GE_XPE
cards using PCLI.
Tools/Equipment
None
Prerequisite Procedures
Required/As Needed
As needed
Onsite/Remote
Onsite or remote
Security Level
Provisioning or higher
Command or Action
Purpose
Step 1
configure terminal
Example:
MSTP 176# configure terminal
Enters global configuration mode.
Step 2
interface type port
Example:
MSTP 176# (config) interface giga 1
MSTP-176# (config-if)#
Enters interface configuration mode.
Step 3
rep stcn segment id
Example:
MSTP 176 (config-if)# rep stcn segment
25
Configures a edge port to send REP STCNs to a specific segment.
Command or Action
Purpose