Cisco Cisco Prime Optical 9.6 Riferimenti tecnici
35
Cisco Prime Optical 9.6 ML Provisioning Methodology
OL-27085-01
Using the Quality of Service Policy Template
Adding UNI dot1Q Access
is an example of the Create Layer 2 Service wizard for adding UNI dot1Q access.
Figure 17
Create Layer 2 Service Wizard—Adding UNI dot1Q Access
The port is recognized as UNI if you enter the service-policy input command on the port interface;
otherwise, the port is recognized as NNI. Every subinterface is a dot1q connection. The classification of
UNI versus NNI is based on the port-level parsing. A connection is untagged if you enter the encap
dot1q 1 command. The multiple class map and QoS policy configurations for advanced QoS are similar
to the QinQ Access example shown in
otherwise, the port is recognized as NNI. Every subinterface is a dot1q connection. The classification of
UNI versus NNI is based on the port-level parsing. A connection is untagged if you enter the encap
dot1q 1 command. The multiple class map and QoS policy configurations for advanced QoS are similar
to the QinQ Access example shown in
.
Enter the following commands to create a UNI Dot1q:
[Interface configuration]
[First time only; first dot1q on this UNI port]
Interface {GigabitEthernetport|FastEthernetport}
Service-policy input POLICY_{GIGE|FE}port_IN
Service-policy output POLICY_QOS_OUT
Interface {FastEthernetport|GigabitEthernetport}.Port VLAN
Description QoS profile name
Encapsulation dot1q Port VLAN
Bridge-group BG
[In the following command executed by Prime Optical, RSTP is not enabled]
Bridge-group BG spanning-disable