Cisco Cisco Prime Optical 9.6 Riferimenti tecnici
39
Cisco Prime Optical 9.6 ML Provisioning Methodology
OL-27085-01
IP Service-Level Agreement on ML-Series Cards
In the Service Drops Configuration pane > IP SLA tab (see
), IP addresses are automatically
generated and assigned to all of the service drop points that Prime Optical manages.
Figure 19
Create Layer 2 Service Wizard—IP SLA
For information about commands that are issued based on the provisioning in the Service Drops and Port
Attributes tabs, see
Attributes tabs, see
The following commands are issued when you assign an IP address to the service drop and specify the
routing protocol.
routing protocol.
IP Address Assignment
ip address IP Address Subnet
[IP Address range is from 192.168.0.1 to 192.168.255.255.
Subnet value is 255.255.0.0.]
Routing Protocol Assignment
bridge bridgegroupno route ip
[Unique bridgegroupno is created by Prime Optical. The
range is from 1 to 255.]
2. Create an IP SLA Session
Create an IP SLA session between a pair of ML-series cards, or between an ML-series card and non-ML
IP addresses. Select either Cisco-supported service points or external-destination IP addresses.
IP addresses. Select either Cisco-supported service points or external-destination IP addresses.
You can use the VLAN table (when a managed VLAN is selected) with the Create IP SLA wizard (see
) to provision the IP SLA session.