Cisco Cisco Content Delivery Engine 250 Guida All'Installazione

Note: if sdt returns the following error:

*****************************************************************************
SuperDoctor II - Linux version 2.88(120726)
Copyright(c) 1993-2012 by Super Micro Computer, Inc.

http://supermicro.com/

*****************************************************************************
Error: no i2c device files found. Please use mkdev.sh to create them.

Run the following command: /usr/sbin/enable_ipmi.sh
Then run the “sdt” CLI command again.

2.3.3 Validation on VDS-IS (Release 3.2)

For Release 3.2 (and beyond), simply execute the “show hardware health” CLI
command. Verify this command does not hang, and that the IPMI firmware version indicates
“3.9” (example output is shown below):

DD13-2S10-2#sh hardware health

----------------- System Hardware Health ------------------

*****************************************************************************
  Supero Doctor II - Linux version 2.79(110504)
  Copyright(c) 1993-2010 by Super Micro Computer, Inc. http://supermicro.com/
*****************************************************************************
Monitored Item High Limit Low Limit Status
----------------------------------------------------------------------
Fan1 Fan Speed     715 5625
Fan2 Fan Speed 715 5273
Fan7 Fan Speed 715 5273
Power1 Fan 1 Speed 4007 7099
Power1 Fan 2 Speed     4007 10992
CPU1 Vcore Voltage 1.49 0.60 1.04
CPU2 Vcore Voltage 1.49 0.60 0.98
CPU1 VTT Voltage 1.34 0.92 1.14
CPU2 VTT Voltage 1.65 0.92 1.12
CPU1 DIMM Voltage 1.65 1.20 1.52
CPU2 DIMM Voltage 1.65 1.20 1.52
+1.5V Voltage 1.65 1.35 1.46
+1.8V Voltage 1.98 1.62 1.80
+5V Voltage       5.50 4.51 5.09
+12V Voltage 13.19 10.80 12.07
+1.1V Voltage 1.21 0.98 1.10
+3.3V Voltage 3.65 2.95 3.29
+3.3Vsb Voltage 3.65   2.95 3.24
VBAT Voltage 3.65 2.95 2.96
CPU1 Temperature 95/203 Low
CPU2 Temperature 95/203 Low