Cisco Headend System Release 2.7
Set Up the BFS
78-745238-01 Rev D
15
Add the Inband Carousel to the PAT Table
Determining the Session Number
1 On the DNCS Administrative Console, click the DNCS tab.
2 Click the Application Interface Modules tab.
3 Click Source. The Source List window opens.
1 On the DNCS Administrative Console, click the DNCS tab.
2 Click the Application Interface Modules tab.
3 Click Source. The Source List window opens.
4 Click the Source ID column header to sort the list of sources by source ID.
5 Write down two unused source numbers greater than 200 in the following
5 Write down two unused source numbers greater than 200 in the following
spaces.
Services Portal Inband Source _______________
Services Portal Out-of-band Source _______________
Services Portal Inband Source _______________
Services Portal Out-of-band Source _______________
Notes:
You will use the inband source number as the session number for the inband
carousel in this procedure.
You will use both the inband source and the out-of-band source numbers
later in this section.
Our numbering convention uses even numbers for inband sources and odd
numbers for out-of-band sources.
We recommend that the inband and out-of-band source IDs are sequential if
possible. For example, source ID 202 for inband and source ID 203 for out-of-
band.
You must use numbers greater than 200. Source IDs 1 through 200 are
reserved for system-built sources.
6 Close the Source List window from the File menu.