Cisco Model GS7000 4-Port Node 1 GHz with 42 54 Split Guida All'Installazione
Local Control Module
Configuration Procedure
4015678 Rev B
25
a Set the minimum and maximum power thresholds for transmitters TX1
through TX4.
Note: The defaults are 0.5 mW minimum and 2.3 mW maximum.
6 Select menu item 5 - Node Settings and enter its sub-menu.
a Set the appropriate settings for your installation. The default settings are as
follows:
AB Switch 1, AB Switch 2: Preferred A
Reverse Port 1, 2, 4, and 5: On, 0 dB
Laser Type: Analog Laser
Forward Seg: Dual
Reverse Seg: Combined
Note: See LCM Configuration Parameters (on page 18) for other setting
options.
Reverse Port 1, 2, 4, and 5: On, 0 dB
Laser Type: Analog Laser
Forward Seg: Dual
Reverse Seg: Combined
Note: See LCM Configuration Parameters (on page 18) for other setting
options.
Note: Other LCM menu items are not directly related to configuration of the node,
but are primarily read-only status indications. Other menu items of interest are:
but are primarily read-only status indications. Other menu items of interest are:
Menu item 9 - Restore Defaults, that allows the restoration of the default settings
which is for a fully populated node with two AC lines, two power supplies, four
receivers, and four transmitters installed.
which is for a fully populated node with two AC lines, two power supplies, four
receivers, and four transmitters installed.
Menu item 9 - Copy Parameters, that allows you to store up to nine node
configuration parameter settings and copy (restore) them to another LCM
located in different node.
configuration parameter settings and copy (restore) them to another LCM
located in different node.