Cisco Headend System Release 2.7 Guida All'Installazione
Chapter 2 Installing the Software
32
4026031 Rev B
Restarting Billing and Other Third-Party Applications
Contact your billing vendor to restart the billing interface. If you stopped any third-
party interfaces, restart those interfaces as well.
party interfaces, restart those interfaces as well.
What's Next?
The next action you take depends upon whether or not your system uses the
Regional Control System (RCS) option.
Regional Control System (RCS) option.
If your system uses the RCS option, go to Restarting RNCS Processes
(on page 32).
(on page 32).
If your system does not use the RCS option, go to Complete System Validation
Tests (on page 35).
Tests (on page 35).
Note: If you are unsure whether or not your system uses the RCS option, go to
Determining Whether RCS Is Enabled (on page 11).
Determining Whether RCS Is Enabled (on page 11).
Restarting RNCS Processes
If you determined earlier that your system uses the RCS feature, use one of the
following methods to restart Remote Network Control Server (RNCS) processes at
each remote site in your RCS:
following methods to restart Remote Network Control Server (RNCS) processes at
each remote site in your RCS:
Use the siteCmd command to restart RNCS processes at all sites in your system.
Go to Restarting RNCS Processes at All Sites (on page 32).
Go to Restarting RNCS Processes at All Sites (on page 32).
Use the siteControl command to restart RNCS processes at each site in your
system, one site at a time. Go to Restarting RNCS Processes at One Site
(on page 33).
system, one site at a time. Go to Restarting RNCS Processes at One Site
(on page 33).
Restarting RNCS Processes at All Sites
1 Open an xterm window on the DNCS, and log on as the dncs user.
2 To restart RNCS processes at all sites in your system, type siteCmd –a lionnStart
1 Open an xterm window on the DNCS, and log on as the dncs user.
2 To restart RNCS processes at all sites in your system, type siteCmd –a lionnStart
and press Enter. When the system prompts you to verify that you want to “start
the LIONN” (all RNCS processes at all sites).
the LIONN” (all RNCS processes at all sites).
3 Type Y (yes) and press Enter to confirm that you want to restart the processes on
all sites in your system. The system informs you that it is starting LIONN
Applications (processes on all sites in your system), and displays the command
prompt for the DNCS user. If necessary, manually run the IPG collector, and
then go to Complete System Validation Tests (on page 35).
Applications (processes on all sites in your system), and displays the command
prompt for the DNCS user. If necessary, manually run the IPG collector, and
then go to Complete System Validation Tests (on page 35).
4 To exit, type x and then press Enter.
5 If necessary, manually run the IPG collector.
6 Go to Complete System Validation Tests (on page 35).
5 If necessary, manually run the IPG collector.
6 Go to Complete System Validation Tests (on page 35).