Cisco Cisco Tidal Enterprise Scheduler 6.2 Guida Utente
C H A P T E R
7
Cisco Tidal Enterprise Scheduler Web Service Adapter Guide
6.2.1
2
Configuring the
Web Service Adapter
Overview
While the Web Service adapter software is already installed as part of a normal installation of Scheduler,
you must perform the following steps to license and configure the adapter before you can run Web
Service jobs:
you must perform the following steps to license and configure the adapter before you can run Web
Service jobs:
•
– License the connection(s) to the Web Service instance. You cannot define a
Web Service connection until you have applied the Web Service license from Cisco.
•
– Define a Web Service Authentication user to authorize a
connection to be established to the Web Service's Web server and permit requests to be made on
behalf of the authenticated account.
behalf of the authenticated account.
•
– Configure the HTTPS protocol if used in your environment.
•
– Define a Web Service connection so the master can
communicate with the Web Service.
•
– Verify the Web Service connection is healthy.
See
for information about general and adapter-specific properties that can be
set to control things like logging and connection properties.
Licensing an Adapter
Each TES Adapter must be separately licensed. You cannot use an Adapter until you apply the license
file. If you purchase the Adapter after the original installation of TES, you will receive a new license file
authorizing the use of the Adapter.
file. If you purchase the Adapter after the original installation of TES, you will receive a new license file
authorizing the use of the Adapter.
You might have a Demo license which is good for 30 days, or you might have a Permanent license. The
procedures to install these license files are described below.
procedures to install these license files are described below.
To license an Adapter:
Step 1
Stop the master:
Windows:
a.
Click
Start
and select
Programs>TIDAL Software>Scheduler>Master>Service Control
Manager
.