Cisco Cisco RF Gateway 1

 

78-4025112-01 Rev H0 

11 

 

 

2  In the appropriate field, change the IP Address, Subnet Mask, and Default Gateway 

settings. 

3  Click Apply. 
4  Click Save. 
5  Reboot the device.  

Note: The management port IP address is not dynamically configurable, thus 
reboot/power-cycle is required after changes. 

To Configure the Conditional Access (CA) Port IP Address, Subnet Mask, and Default Gateway 
1  Navigate to the System/IP Network page. 

Result: The IP Network page is displayed. 

 

Note: The CA port is only used for scrambling when the EIS and or ECMG 
equipment is on a separate network. 

2  Set the Port Control to On. The default setting is Off. 
3  In the appropriate field, change the IP Address, Subnet Mask, and Default 

Gateway settings. 

4  Click Apply. 
5  Click Save. 
6  Reboot the device.  

Note: The CA port IP address is not dynamically configurable, thus 
reboot/power-cycle is required after changes.