Cisco Cisco StadiumVision Director Guida All'Installazione
© 2011 Cisco Systems, Inc. All rights reserved
Page 12 of 71
By installing two power supply modules on the SV Director Server, the hot-swap
feature allows you to replace a failed power supply without interrupting the
appliance operation. During this hot-swap replacement, a maximum of two
minutes is recommended.
feature allows you to replace a failed power supply without interrupting the
appliance operation. During this hot-swap replacement, a maximum of two
minutes is recommended.
Warning! Never install an AC power module and a DC power module in the
same chassis. Statement 1050
same chassis. Statement 1050
AC Power Supply Safety Considerations
Ensure all power connections conform to the rules and regulations in the
National Electrical Codes (NECs), as well as local codes. Follow these
precautions and recommendations when planning power connections to your
appliance:
National Electrical Codes (NECs), as well as local codes. Follow these
precautions and recommendations when planning power connections to your
appliance:
Check the power at your site before installation and periodically after
installation to ensure that you are receiving clean power (free of spikes and
noise). Install a power conditioner if necessary.
noise). Install a power conditioner if necessary.
The AC power supply includes the following features:
- Auto selects either 110-V or 220-V operation.
- All units include an electrical cord. (A label near the power cord indicates
- All units include an electrical cord. (A label near the power cord indicates
the correct voltage, frequency, current draw, and power dissipation for the
appliance.)
appliance.)
Warning!
This product relies on the building’s installation for short-circuit
(overcurrent) protection. Ensure that fuse or circuit breaker no larger than 120
VAC, 15A U.S. (240 VAC, 10A international) is used on the phase conductors
(all current-carrying conductors). Statement 13
VAC, 15A U.S. (240 VAC, 10A international) is used on the phase conductors
(all current-carrying conductors). Statement 13
Install proper grounding to your server and host equipment rack to avoid damage
from lightning and power surges.
from lightning and power surges.
Warning! This equipment must be grounded. Never defeat the ground conductor
or operate the equipment in the absence of a suitably installed ground conductor.
Contact appropriate electrical inspection authority or an electrician if you are
uncertain that suitable grounding is available. Statement 1024
or operate the equipment in the absence of a suitably installed ground conductor.
Contact appropriate electrical inspection authority or an electrician if you are
uncertain that suitable grounding is available. Statement 1024
The AC-input power supply operates on input voltage and frequency within the
ranges of 100 to 240 VRMS and 50/60 Hz without the need for operator
adjustments.
ranges of 100 to 240 VRMS and 50/60 Hz without the need for operator
adjustments.
Cable Management
Cable management is the most visual aspect of your server setup. However,
cable management is often overlooked because it can be time consuming.
cable management is often overlooked because it can be time consuming.
Equipment racks and enclosures house more equipment today than ever before.
This growth has increased the need for organized cable management both inside
and outside the rack. Poor cable management not only leads to damaged cables
or increased time for adding or changing out cables, but also blocks critical
airflow or access. These problems can lead to inefficiencies in the performance
of your equipment or even downtime.
This growth has increased the need for organized cable management both inside
and outside the rack. Poor cable management not only leads to damaged cables
or increased time for adding or changing out cables, but also blocks critical
airflow or access. These problems can lead to inefficiencies in the performance
of your equipment or even downtime.