Cisco Cisco StadiumVision Director Manuale Di Manutenzione
lists the specifications of the dual video regions.
Table 7. Full Screen Dual Video Template Specifications
Region
Specification
Video 1
l
Can be controlled using an infrared remote (IR) remote or local control.
l
In the template, video region 1 appears as the bottom or primary layer.
l
Supports audio.
l
Source: Local or multicast video.
Video 2
l
Cannot be controlled through an IR remote or local control.
l
In the template, video region 2 fully overlaps video region 1.
l
Luminance (luma) keying is applied to second video region (it cannot be
disabled or changed in the template).
disabled or changed in the template).
l
Does not play audio.
l
Source: Local or multicast video.
NOTE:
The luma key default is set to #ff2000. To enable luma
keying, click the checkbox. To change the global luma key value
from the Management Dashboard, go to SV Director
Configuration > System Configuration > Global
DMP Settings > SV-4K Settings.
from the Management Dashboard, go to SV Director
Configuration > System Configuration > Global
DMP Settings > SV-4K Settings.
NOTE:
For additional information on luma keying, refer to the
.
Guidelines for Dual Video Screen Templates (SV-4K and DMP-2K
Media Players Only)
When using the dual video template for the media players, consider the following:
l
A combination of up to full-HD (1920x1080) at either 30 or 60 fps for local video
and multicast video are hardware-accelerated.
l
While using multicast videos for both video regions is supported, it is
recommended to use a combination of multicast and locally stored videos for the
video regions.
l
Video regions must be placed below any non-video content for consistent
playback and performance.
l
Match the template region aspect ratio with the aspect ratio of the video content
© Cisco Systems, Inc. All rights reserved.
7 of 48