Cisco Cisco StadiumVision Director Manuale Di Manutenzione
© 2011 Cisco Systems, Inc. All rights reserved.
Page 59 of 103
There are two categories of Display Specs for each type of TV: Basic Info and Serial
Commands. Display specifications for several common TV types are included with
CISCO STADIUMVISION DIRECTOR when installed. If the TV that you are
installing is not listed then refer to the manufacturer’s documentation to obtain the
necessary codes. The TV qualification section describes this in further detail. Once
the codes have been obtained add a new display spec for the TV as follows:
Commands. Display specifications for several common TV types are included with
CISCO STADIUMVISION DIRECTOR when installed. If the TV that you are
installing is not listed then refer to the manufacturer’s documentation to obtain the
necessary codes. The TV qualification section describes this in further detail. Once
the codes have been obtained add a new display spec for the TV as follows:
1. Access StadiumVision Director by opening a browser window and entering the
following:
https://SV_Director_IP_addr:8080/
where SV_Director_IP_addr is the IP Address for the StadiumVision Director.
The StadiumVision Director main screen displays, as shown in
Figure 43.
Cisco StadiumVision Director Main Screen
2. Click Control Panel.
3. Select Setup > Devices.
4. Click on the Display Specifications tab.
5. Click the “+” at the upper right of the Display Spec list box.