Cisco Cisco MXE 3500 (Media Experience Engine)
8
Integration Note for Configuring Cisco MXE 3500 Release 3.2 with Cisco Show and Share Release 5.2.1 or Later
Configure Cisco Show and Share to Use the Cisco MXE 3500 for Transcoding Videos
Step 5
Enter the FTP credentials that you configured on the Cisco MXE 3500:
Step 6
Click Save. Cisco DMM verifies the connection to the Cisco MXE 3500. If it cannot contact the
Cisco MXE 3500, an error message appears.
Cisco MXE 3500, an error message appears.
Step 7
If you receive an error, verify your settings. If you configured the FTP password incorrectly, complete
the following steps to reset the password on the Cisco MXE 3500 and then return to
the following steps to reset the password on the Cisco MXE 3500 and then return to
to register
the Cisco MXE 3500 again.
a.
Use SSH to access Linux.
b.
Log into Linux as admin. The default password is change_it. The configuration menu appears.
ssh admin@<linux_ip>
Password: change_it
c.
Select System Command Prompt. The command line interface appears.
d.
Become root.
su -
e.
Enter the following commands:
cd
pam_tally --user dmsftp --reset
Configure Cisco Show and Share to Use the Cisco MXE 3500 for
Transcoding Videos
Transcoding Videos
Procedure
Step 1
Log into Cisco Show and Share with admin or superuser privileges.
Step 2
Chose Administration from the global navigation.
Field
Value
Username
The username of the FTP account that you created in the
procedure. For example, dmsftp.
Password
The password for the FTP account that you created the
procedure.