Cisco Cisco Digital Media Player 4310G Guida Utente
Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
User Guide for IGMPv3 Configuration
Source Specific Multicast for DMP4310G
Source Specific Multicast for DMP4310G
Revised: April 29, 2015
•
•
•
About This Guide
Note
When the multicast router is operating in IGMPv2 mode, DMP 4310G will use IGMP v2 by default.
This guide goes through the configuration steps for enabling IGMPv3 Source Specific Multicast (SSM)
in a digital signage deployment utilizing Cisco DMP4310G devices. It assumes that you have already
completed setup procedures for your DMP, and therefore:
in a digital signage deployment utilizing Cisco DMP4310G devices. It assumes that you have already
completed setup procedures for your DMP, and therefore:
•
Your DMP is already connected to:
–
A network that includes a DHCP server – unless your DMP will use pseudo-IP addressing.
–
Its LCD display (or equivalent).
–
Its AC power source.
•
You Already:
–
Checked the LEDs to confirm that your DMP has power and has obtained an IP address.
–
Learned what dynamic IP address the DHCP server assigned to your DMP.
–
Used your browser to log in to the DMPDM administrative account.
–
Changed the factory-default passwords.
–
Used DMPDM to configure video output to the presentation system.