Cisco Cisco Digital Media Player 4310G Guida Utente
5
User Guide for IGMPv3 Configuration Source Specific Multicast for DMP4310G
Configuring the DMP for SSM
Configuring the DMP for SSM
Note
It is helpful to turn on debugging for the router closest to the multicast source to verify that the multicast
traffic is being properly received.
traffic is being properly received.
Router(config-if)# debug ip igmp
Step 1
Configure (enable) the DMP for IGMPv3 by issuing the following MIB command string from a web
browser – be sure to input the IP address of your DMP.
browser – be sure to input the IP address of your DMP.
https://<ip of dmp>/set_param?init.force_igmp_version=3
Tip
If there are a large number of DMP devices to be configured, this MIB command may be more efficiently
issued through a custom-created Advanced Task through the DMM interface. Once created, this
Advanced Task can be issued to entire groups of DMPs.
issued through a custom-created Advanced Task through the DMM interface. Once created, this
Advanced Task can be issued to entire groups of DMPs.
Step 2
Log into the DMPDM of a DMP as an administrator by using a web browser and the IP address of the
DMP.
DMP.
Step 3
Save and Restart the DMP in order save/preserve the IGMPv3 setting. If this step is not performed, the
DMP will revert back to IGMPv2 (default setting) upon the next reboot.
DMP will revert back to IGMPv2 (default setting) upon the next reboot.
Step 4
Select Media Playback from the left-hand column of settings within the DMPDM.