Cisco Cisco TelePresence MX700 Dépliant
Cisco TelePresence Endpoints and Cisco Unified Communications Manager
Quick Reference Guide
D14996.02 Administering TC6.1 Endpoints on CUCM 9.1.1, April 2013.
www.cisco.com — Copyright © 2013 Cisco Systems, Inc. All rights reserved.
4
Introduction
This document describes the tasks you must perform to
register a Cisco TelePresence endpoint (C, EX, MX, SX, and
Profile Series) on Cisco Unified CM (CUCM).
The software versions referred to in this document are
TC6.1 for the endpoints and CUCM 9.1.1. Cisco recommend
using the latest software versions to support all features and
functions described in this guide.
Most configurations will also apply to CUCM 8.6.2, but some
menus have changed in newer versions of the CUCM.
Prerequisites
Users of this guide are assumed to be familiar with the basics
of the user interface of the Cisco Unified CM and Cisco
TelePresence endpoints.
About CUCM configuration
This document do not describe configuration of the CUCM
such as voice mail, call forward, etc. refer to the user
documentation:
About endpoint configuration
This document does not describe the basic configuration of
the endpoint, such as user accounts, network configuration,
date & time, etc. refer to the user documentation:
About device packages
The Cisco Unified CM Device Package contains device
configuration capabilities for the Cisco TelePresence
endpoints (C, EX, MX, SX, and Profile Series).
This guide reflects the values/parameters in Cisco
Unified CM Device Package 9.1.1.
The Cisco Unified CM Device Package 9.1.1 is available for
download on the Cisco web site. Go to:
.
About endpoints previously used with TMS
If the endpoint has previously been used with Cisco
TelePresence Management Suite (TMS) make sure the
endpoint is purged from TMS.
About endpoints factory reset
In most cases a factory reset of the endpoint is not needed
before provisioning it to the Cisco Unified CM. But, in some
cases it is recommended to factory reset the endpoint before
provisioning:
• When the system has been used with Cisco
TelePresence Management Suite (TMS), or a similar
system.
• When the system is re-deployed to another user.
• When changing the security configuration.
• When moving the system to another security
• When changing the security configuration.
• When moving the system to another security
environment.
Factory reset is described in the Appendices section. refer
Contents
Introduction
CUCM configuration
Endpoint configuration
About passwords
Appendices
Introduction