Cisco Cisco ONS 15310-MA SONET Multiservice Platform Guida All'Installazione
3
Installing the DS1-28/DS3-EC1-3 and DS1-84/DS3-EC1-3 Cards in the Cisco ONS 15310-MA
78-17332-01
DS1-28/DS3-EC1-3 and DS1-84/DS3-EC1-3 Card Specifications
DS1-28/DS3-EC1-3 and DS1-84/DS3-EC1-3 Card Specifications
The ONS 15310-MA DS1-28/DS3-EC1-3 and DS1-84/DS3-EC1-3 cards have the following
specifications:
specifications:
For DS1:
•
Input
–
Bit rate: 1.544 Mbps +/- 32 ppm
–
Frame format: Unframed, SF (D4), ESF
–
Line code: AMI, B8ZS
–
Termination: AMP Champ
–
Input impedance: 100 ohms
–
Cable loss: Max 655 feet ABAM #22 or #24 AWG
–
AIS: TR-TSY-000191 compliant
•
Output
–
Bit rate: 1.544 Mbps +/- 32 ppm
–
Frame format: Unframed, SF (D4), ESF
–
Line code: AMI, B8ZS
–
Termination: AMP Champ
–
Input impedance: 100 ohms
–
Cable loss: Max 655 feet ABAM #22 or #24 AWG
–
AIS: TR-TSY-000191 compliant
–
Power level: 12.5 to 17.9 dBm, centered at 772 KHz, –16.4 to –11.1 dBm centered at 1544 KHz
–
Pulse shape: Telcordia GR-499-CORE Figure 9-5
–
Pulse amplitude: 2.4 to 3.6 V peak-to-peak
–
Loopback modes: Terminal and facility
–
Line build out: 0 - 131 ft., 132 - 262 ft., 263 - 393 ft., 394 - 524 ft., 525 - 655 ft.
•
Electrical interface: 64-pin Champ connectors on high-density EIA
Table 1
DS1-28/DS3-EC1-3 and DS1-84/DS3-EC1-3 Card-Level Indicators
Card-Level Indicators
Description
Red FAIL LED
Indicates that the card processor is not ready. This LED is on during reset.
The FAIL LED flashes during the boot process. Replace the card if the red
FAIL LED persists in flashing.
The FAIL LED flashes during the boot process. Replace the card if the red
FAIL LED persists in flashing.
ACT/STBY LED
Green (Active)
Amber (Standby)
When the ACT/STBY LED is green, the card is operational and ready to
carry traffic. When the ACT/STBY LED is amber, the card is operational and
in standby (protect) mode.
carry traffic. When the ACT/STBY LED is amber, the card is operational and
in standby (protect) mode.
Amber DS1 and DS3 SF
LEDs
LEDs
Indicates a signal failure or condition such as LOS or LOF on one or more
card ports.
card ports.