Access os5 Manuale Utente
110
CHAPTER 8
Multi Mode & System Setup
Multi Mode & System Setup
Multi Mode
Parameters
Parameters
Please bear in mind the PART- and/or
MULTI-related parameters described in the fol-
lowing are available in MULTI mode only.
lowing are available in MULTI mode only.
SELECT BANK
Activates the bank for a SINGLE PROGRAM for
the current PART.
the current PART.
01111111111111111112
1 B36 101BASS RP
SelectBank B≤
SelectBank B≤
61111111111111111154
SELECT NUMBER
Activates a SINGLE PROGRAM for the current
PART.
PART.
01111111111111111112
1 B36 101BASS RP
SelctNumber 36≤
SelctNumber 36≤
61111111111111111154
PART TRANSPOSE
Transposes the PART in semitone steps.
01111111111111111112
1 B36 101BASS RP
PartTransp +0≤
PartTransp +0≤
61111111111111111154
PART DETUNE
Fine-tunes the PART.
01111111111111111112
1 B36 101BASS RP
PartDetune +10≤
PartDetune +10≤
61111111111111111154
PART VOLUME
Controls the volume level of the PART. In addi-
tion to PATCH VOLUME (in the EDIT menu, see
appropriate section), MIDI Volume (Controller
#7) and Expression (Controller #11), PART VOL-
UME is the fourth option for determining the
volume level of a PART within a MULTI program.
Please keep in mind that PART VOLUME is a bi-
polar parameter: In the negative half of the con-
trol range (-64 to 0) the signal level is controlled
in the normal fashion - i.e. the sound fades out
as negative numbers increase; from the center
value upwards (0 to +63), extremely low-level
signals are amplified. When you set values
greater than 0 for sounds that are already fairly
loud, you may hear undesirable digital distor-
tion.
tion to PATCH VOLUME (in the EDIT menu, see
appropriate section), MIDI Volume (Controller
#7) and Expression (Controller #11), PART VOL-
UME is the fourth option for determining the
volume level of a PART within a MULTI program.
Please keep in mind that PART VOLUME is a bi-
polar parameter: In the negative half of the con-
trol range (-64 to 0) the signal level is controlled
in the normal fashion - i.e. the sound fades out
as negative numbers increase; from the center
value upwards (0 to +63), extremely low-level
signals are amplified. When you set values
greater than 0 for sounds that are already fairly
loud, you may hear undesirable digital distor-
tion.
01111111111111111112
1 B36 101BASS RP
PartVolume +0≤
PartVolume +0≤
61111111111111111154
OUTPUT SELECT
When you select an internal aux path as a sig-
nal output, you of course must route the signal
of another PART to this aux path via INPUT SE-
LECT before you can establish a signal connec-
nal output, you of course must route the signal
of another PART to this aux path via INPUT SE-
LECT before you can establish a signal connec-