Access os5 Manuale Utente

Pagina di 198
112
CHAPTER 8
Multi Mode & System Setup
date a new voice. When you set the Priority of a
PART to ”High”, the VIRUS will not ”steal” any
notes from the voices of this PART. Use this pa-
rameter sparingly. In other words, if you set all
Parts to High, you’re defeating the purpose of
this parameter. In this case, it wouldn’t have any
effect since the priority of all voices is the same.
01111111111111111112
 1 B36 101BASS RP
 Priority    Low≤   
61111111111111111154
KEYRANG
In MULTI mode, you can limit the note range of
individual PARTs. Use the LowKey and HighKey
parameters to define the upper and lower limits
of the note range to which the PART will re-
spond. This lets you assign the sounds of sev-
eral PARTs that are addressed by the same
MIDI channel to different keyboard zones to
create what are called split sounds.
If, however, you adjust the two parameters so
that the value of LowKey lies above that of
HighKey, the note range between these two
high and low limits is disabled and the PART will
respond only to notes the lie above and below
this zone.
LOW KEY
Determines the lowest MIDI note that the PART
responds to.
01111111111111111112
 1 B36 101BASS RP
 LowKey      C-2≤   
61111111111111111154
HIGH KEY
Determines the highest MIDI note that the PART
responds to.
01111111111111111112
 1 B36 101BASS RP
 HighKey      G8≤   
61111111111111111154
MIDI VOLUME
ENABLE Switches a given PART’s MIDI receive
mode for MIDI Controller 7 (volume) ON and
OFF.
01111111111111111112
 1 B36 101BASS RP
 MidiVolume  Off≤   
61111111111111111154
HOLD PEDAL
ENABLE Switches a given PART’s MIDI receive
mode for the hold pedal (MIDI Controller #64)
ON and OFF.
01111111111111111112
 1 B36 101BASS RP
 HoldPedal   Ena≤   
61111111111111111154