HP 20-700 Manuale Utente

Chapter 4

Operating in Automated Mode 107

Chapter 4

Importing Data Cartridges through the CAP

To open the CAP and import data cartridges:
1. Press the [CAP A] or [CAP B] button on the operator panel to open the 

CAP. 
The indicator will light.

Caution

Possible halt to operation or damage to components. You must 

enter the cartridges properly or you might damage the robot or 

the drive, or cause the library to stop operating. Use only 

cartridges designed for your type of drives.

Refer to 

 on page 109 and 

 on page 110 while performing 

the following steps.
2.  Load cartridges into the magazine by lifting up, then pulling out and down 

on the magazine handle to gain access to the slots. If desired, you can 

also remove the magazine from the CAP by lifting it out (see 

page 108).

Note

You can use the snap-on retention cartridge cover to keep 

cartridges in place when carrying the magazine. Remove the 

clear cover from the back of the magazine by lifting the side 

edge. To protect the cartridges, place the slots on one edge of 

the cover into the grooves on the side of the magazine’s top 

panel and snap the other edge into place.

3.  Enter the cartridges into the magazine so that they lie flat, with the bar 

code up and the reel facing away from you.

Caution

Remove the retention cover before loading the magazine into the 

CAP.

4.  Return the magazine to its closed position.
5. Press 

the 

[CAP A] or [CAP B] button on the operator panel to close the 

CAP.