HP color laserjet 2550 series Manuale Di Servizio
8. Rotate the gear assembly away from the printer, beginning with the front edge.
Note
A grounding spring (callout 8, hidden) should remain attached to the printer chassis. If it
does not, then either reattach it to the chassis or place it with the gear assembly to prevent
misplacing it.
does not, then either reattach it to the chassis or place it with the gear assembly to prevent
misplacing it.
7
8
Figure 5-36.
Removing the gear assembly (2 of 2)
Reinstallation tip
A grounding wire at the lower-back corner of the gear assembly must be hooked around
the chassis at reinstallation. Callout 2 in
the chassis at reinstallation. Callout 2 in
shows the grounding wire, and callout 3 shows the grounding spring attached to the
chassis.
chassis.
Align the following parts with the printer chassis:
●
gear assembly shaft
●
grounding spring
●
grounding wire
Waste-toner sensor
1. Unroute the cable from several cable holders.
2. Remove one screw (callout 1).
138
Chapter 5 Removal and replacement
ENWW