HP digital sender 9200c Manuale Di Servizio
6
Disconnect one connector (callout 6), remove two screws (motor) (callout 7), and remove the
scanner motor (the belt will loosen).
scanner motor (the belt will loosen).
7
6
Figure 6-102
Removing the scanner motor (5 of 5)
NOTE
Make sure that the motor bracket alignment pins in the flatbed are correctly
positioned in the bracket.
Do not forget to install the grounding clips (bottom) when reinstalling the motor bracket.
When reinstalling the scanner motor, the grounding strip must be inside the optical guide
shaft retainer.
shaft retainer.
When installing the optical assembly, make sure that the teeth on the belt face inward so
that they engage the drive portion of the unit.
that they engage the drive portion of the unit.
Internal components
143