HP officejet d Manuale Utente
work with printheads and ink cartridges
39
hp officejet d series
5
If there is plastic tape on the failed printhead, remove the plastic tape.
6
Push the failed printhead firmly down into the appropriate slot using
the printhead handle. Do not touch the printhead tower, and do not
remove the printhead handle.
the printhead handle. Do not touch the printhead tower, and do not
remove the printhead handle.
7
Move the print carriage latch down, and make sure the loops catch
the hooks. Snap the latch into place, then close the print carriage
access door.
the hooks. Snap the latch into place, then close the print carriage
access door.
8
If the error message still appears, remove and reinsert the printhead
again and close the print carriage access drawer.
again and close the print carriage access drawer.
9
If the error message still appears, replace the printhead as described
in the following section.
in the following section.
replace the
printheads
printheads
If you experience print quality issues that cannot be resolved by cleaning
your printheads and you have verified that the printheads need to be
replaced, you may need to replace them. You may also see front-panel
display messages that indicate when individual printheads need to be
replaced.
your printheads and you have verified that the printheads need to be
replaced, you may need to replace them. You may also see front-panel
display messages that indicate when individual printheads need to be
replaced.
See the Support and Specifications booklet for information on ordering
replacement printheads.
replacement printheads.
1
Turn on the unit, then open the print-carriage access door by lifting the
handle until the door locks into place.
The print carriage moves to the center of the unit.
handle until the door locks into place.
The print carriage moves to the center of the unit.
Pull the printhead handle upward