HP officejet d Manuale Utente
work with printheads and ink cartridges
41
hp officejet d series
4
Remove the new printhead from its packaging and, being careful to
touch only the black plastic, gently remove the plastic tape.
touch only the black plastic, gently remove the plastic tape.
Caution! Do not touch the copper contacts, the printhead
tower, or the ink nozzles.
tower, or the ink nozzles.
removing the plastic tape from the printhead
5
Match the color on the top of the printhead to the color on the
printhead carriage.
printhead carriage.
6
Push the new printhead firmly down into the appropriate slot using the
printhead handle. Do not touch the printhead tower, and do not
remove the printhead handle.
printhead handle. Do not touch the printhead tower, and do not
remove the printhead handle.
7
Move the print carriage latch down, and make sure the loops catch
the hooks. Snap the latch into place, then close the print carriage
access door.
the hooks. Snap the latch into place, then close the print carriage
access door.
8
After the message appears in the front-panel display, press Enter to
align the printheads.
A page prints to confirm alignment. You can discard or recycle this
page. If the page does not appear, see the Troubleshooting help,
which you access from the HP Director.
align the printheads.
A page prints to confirm alignment. You can discard or recycle this
page. If the page does not appear, see the Troubleshooting help,
which you access from the HP Director.
handle ink
cartridges
cartridges
Before you replace or clean an ink cartridge, you should know the part
names and how to handle them.
names and how to handle them.
Plastic tape
Printhead tower
Copper contacts
Ink nozzles