HP procurve 2500 Manuale Utente

199    

Enhancements in Release F.02.02
New Time Synchronization Protocol Options

Menu: Viewing and Configuring TimeP

To View, Enable, and Modify the TimeP Protocol:

1.

From the Main Menu, select:

Used to select either TIMEP (the default), SNTP, or None as the time synchronization method. 

The Default. Timep does not operate, even if specified by the Menu interface Time Sync Method 
parameter or the CLI timesync command.

When Timep is selected as the time synchronization method, the switch attempts to acquire a Timep 
server IP address via DHCP. If the switch receives a server address, it polls the server for updates 
according to the Timep poll interval. If the switch does not receive a Timep server IP address, it cannot 
perform time synchronization updates.

When Timep is selected as the time synchronization method, the switch attempts to poll the specified 
server  for updates according to the Timep poll interval. If the switch fails to receive updates from the 
server, time synchronization updates do not occur.

Used only when the TimeP Mode is set to Manual. Specifies the IP address of the TimeP server that 
the switch accesses for time synchronization updates. You can configure one server.

Default: 720 minutes. Specifies the interval the switch waits between attempts to poll the TimeP server 
for updates.