HP procurve 2500 Manuale Utente
20
Enhancements in Release F.05.05 through F.05.70
Enhancements in Release F.05.05 through F.05.60
See Figure 6 below for an example of adding an additional Syslog server.
Figure 6. Configuring multiple Syslog Servers
Operating Notes for Syslog
■
Rebooting the switch or pressing the Reset button resets the Debug Configuration. Any Syslog
server IP addresses written in the startup-config file are saved across a reboot and logging
remains enabled. Any Syslog server IP addresses existing only in the running-config file are lost
if the switch reboots. (Use the
server IP addresses written in the startup-config file are saved across a reboot and logging
remains enabled. Any Syslog server IP addresses existing only in the running-config file are lost
if the switch reboots. (Use the
write memory command to save configuration changes to the
Startup-config file.)
■
Up to six Syslog servers may be configured to receive Event Log messages. All switches must
use the same Syslog facility.
use the same Syslog facility.
Isolated Port Groups (Enhanced)
Isolated Port-Group Commands
[no] port-isolation
port-isolation [ethernet] < port-list > mode
< uplink | public | group1 | group2 | private | local >
show port-isolation
Continuing the example begun in
figure 2, this command adds a
second Syslog server.
figure 2, this command adds a
second Syslog server.
Lists the IP addresses of the Syslog
servers configured on the switch.
servers configured on the switch.
Messages must be sent to the
same facility on each Syslog
same facility on each Syslog