HP procurve 2500 Manuale Utente

    70

Enhancements in Release F.05.05 through F.05.60

Any port VLAN-ID changes you make on 802.1X-aware ports during an 802.1X-authenticated session 
do not take effect until the session ends.

With GVRP enabled, a temporary, untagged static VLAN assignment created on a port by 802.1X 
authentication is advertised as an existing VLAN. If this temporary VLAN assignment causes the 
switch to disable a configured (untagged) static VLAN assignment on the port, then the disabled 
VLAN assignment is not advertised. When the 802.1X session ends, the switch:

■

Eliminates and ceases to advertise the temporary VLAN assignment.

■

Re-activates and resumes advertising the temporarily disabled VLAN assignment. 

Messages Related to 802.1X Operation

Port < port-list > is not an authenti-
cator.

The ports in the port list have not been enabled as 802.1X 
authenticators. Use this command to enable the ports as 
authenticators:

HPswitch(config)# aaa port-access 
                 authenticator e 10

Port < port-list > is not a supplicant.

Occurs when there is an attempt to change the supplicant 
configuration on a port that is not currently enabled as a 
supplicant. Enable the port as a supplicant and then make 
the desired supplicant configuration changes. Refer to 
“Enabling a Switch Port To Operate as a Supplicant” on 
page 58.

No server(s) responding.

This message can appear if you configured the switch for 
EAP-RADIUS or CHAP-RADIUS authentication, but the 
switch does not receive a response from a RADIUS server. 
Ensure that the switch is configured to access at least one 
RADIUS server. (Use show radius.) If you also see the 
message 

Can’t reach RADIUS server < 

x.x.x.x >

, try the suggestions listed for that message