HP proliant dl580 Manuale Utente
Removal and replacement procedures 43
7.
Disconnect and remove the power and SAS cables, if applicable.
To replace the SAS-SATA hard drive cage, perform the following procedures:
CAUTION: The power transfer board is only installed in the HP ProLiant DL585 Server. Installing the power
transfer board in the HP ProLiant DL580 Generation 3 Server might damage the board and server
components.
components.
NOTE: You must provide a SAS controller before proceeding with the SAS hard drive cage installation.
1.
Power down the server (on page
2.
3.
Extend the server from the rack ("
4.
Remove the access panel ("
5.
Install the SAS controller. Refer to the directions provided with the controller for installation
instructions.
instructions.
6.
Route and connect the power cable to the power cable connector on the SCSI backplane.
CAUTION: When routing cables, always be sure that the cables are not in a position where they can be
pinched or crimped.