HP proliant dl580 ユーザーズマニュアル

Removal and replacement procedures  43 

Disconnect and remove the power and SAS cables, if applicable. 

 

To replace the SAS-SATA hard drive cage, perform the following procedures: 

  CAUTION:  The power transfer board is only installed in the HP ProLiant DL585 Server. Installing the power 

transfer board in the HP ProLiant DL580 Generation 3 Server might damage the board and server 
components. 

  NOTE:  You must provide a SAS controller before proceeding with the SAS hard drive cage installation. 

Power down the server (on page 

Remove all hard drives ("

) and hard drive blanks ("

Extend the server from the rack ("

Remove the access panel ("

Install the SAS controller. Refer to the directions provided with the controller for installation 
instructions. 

Route and connect the power cable to the power cable connector on the SCSI backplane. 

  CAUTION:  When routing cables, always be sure that the cables are not in a position where they can be 

pinched or crimped.