Sony HT-SF1300 Manuale Utente

You can also select “A.CAL YES” in the 

 

A. CAL menu.
The following appears on the display.
A.CAL [5] 

t A.CAL [4] t A.CAL [3] t 

A.CAL [2] 

t A.CAL [1]

The measurement process will take 
approximately 30 seconds to complete.
The table below shows the display when 
measurement starts.

You cannot measure the speaker height of the 
surround speakers. Set this value using “SUR POS.” 
parameters in the SYSTEM menu (page 35).

When Auto Calibration starts:
– Stand some distance from the speakers and the 

listening position to avoid measurement failure. 
This is because test signals are output from the 
speakers during measurement.

– Avoid making noise to get a more accurate 

measurement.

The Auto Calibration function will be 
canceled when you do the following during the 
measurement process:
– Press ?/1 or MUTING.
– Press input buttons on the remote or INPUT 

SELECTOR on the receiver.

– Change the volume level.
– Press AUTO CAL again.

When the measurement ends, a beep 
sounds and the measurement result 
appears on the display.

Speaker existance

TONE

Speaker gain, distance, 
frequency response

T.S.P.

Subwoofer gain and distance

WOOFER

?/1

-

O

TV ?/1 

AV ?/1

AUTO CAL

Input 
buttons

?/1 
switch

MASTER 
VOL +/–

MUTING

AMP MENU

When the 
measurement 
process 
completes 
properly

SAVE

Proceed to step 
2.

When the 
measurement 
process fails

ERROR 
XXXX