Elo TouchSystems JH 10T08 Manuale Utente

INB100014-1 (Rev 19)

IND100078-10

General Installation Recommendations

- The impairment of read-out from a display screen by direct light from lamps or the sun must be

  avoided. Rear windows must be blacked out by means of roller blinds or Venetian blinds.

- Disturbing reflections on the screen of a display caused by pilot lamps and illuminated signs must

  be prevented by suitable measures (screening or relocating).

- When a product is being installed, the surface base or bulkhead must be checked to ensure that it

  is flat in order to avoid twisting of the unit when the fixing screws are tightened, because such

  twisting would impair mechanical functions. Any unevenness should be compensated for by

  means of spacing-washers.

- The grounding screws of the units must be connected to the body of the ship (ground); the wire

  used should have a cross sectional area of at least 6 mm

2

.

- Transportation damage, even if apparently insignificant at first glance, must immediately be

   examined and be reported to the freight carrier. The moment of setting-to-work of the equipment

   is too late, not only for reporting the damage but also for the supply of replacements.

Use only high quality shielded signal cables. For RGB/DVI cables use only cables with separate 

coax for Red, Green and Blue. Jakob Hatteland Display can supply a varity of high quality RGB/

DVI, RS232, PARALLEL, LAN and USB cables intended for this use.