Garmin g1000 mooney annunciationsandalerts pilots guide m20m m20r Manuale Utente
190-00444-01 Rev. A
Garmin G1000 Annunciations and Alerts Pilot’s Guide for Mooney M20M & M20R
Miscellaneous Message Advisories (Cont.)
Alerts Window Message
Comments
LOCKED FPL – Cannot navigate locked
flight plan.
flight plan.
This occurs when the pilot attempts to activate a stored flight plan that contains
locked waypoints. Remove locked waypoints from flight plan. Update flight plan
with current waypoint.
locked waypoints. Remove locked waypoints from flight plan. Update flight plan
with current waypoint.
WPT ARRIVAL – Arriving at waypoint
-[xxxx]
-[xxxx]
Arriving at waypoint [xxxx] where xxxx is the waypoint name.
STEEP TURN – Steep turn ahead.
A steep turn is 15 seconds ahead. Prepare to turn.
INSIDE ARSPC – Inside airspace.
Aircraft is inside airspace.
ARSPC AHEAD – Airspace ahead less
than 10 minutes.
than 10 minutes.
Airspace is ahead of aircraft. Aircraft will penetrate airspace within 10 minutes.
ARSPC NEAR – Airspace near and
ahead.
ahead.
Special use airspace is near and ahead of the aircraft position.
ARSPC NEAR – Airspace near – less
than 2 nm.
than 2 nm.
Special use airspace is within 2 nm of the aircraft position.
LEG UNSMOOTH – Flight plan leg will
not be smooth.
not be smooth.
The approaching flight plan waypoints are too close to make smooth turns. Prepare
for steep turns ahead and expect noticeable course deviations.
for steep turns ahead and expect noticeable course deviations.
APPR INACTV – Approach is not
active.
active.
The loaded approach is not active. Activate approach when required.
SLCT AUTOSEQ – Select auto se-
quence mode.
quence mode.
Select auto-sequence mode. Press the
OBS softkey to deactivate the OBS mode.
SLCT FREQ – Select appropriate
frequency for approach.
frequency for approach.
Load the approach frequency for the appropriate NAV receiver. Select the correct
frequency for the approach.
frequency for the approach.
SLCT NAV – Select NAV on CDI for
approach.
approach.
Set the CDI to the correct NAV receiver.
NO WGS84 WPT – Non WGS 84
waypoint for navigation -[xxxx]
waypoint for navigation -[xxxx]
The selected waypoint [xxxx] does not use the WGS 84 datum. Cross-check position
with alternate navigation sources.
with alternate navigation sources.
TRAFFIC FAIL – Traffic device has
failed.
failed.
The traffic information system (TIS) has failed. The G1000 system should be serviced.
STRMSCP FAIL – Stormscope has
failed.
failed.
Stormscope has failed. The G1000 system should be serviced.
BACKUP PATH
– Stormscope using
backup data path.
Stormscope is using the backup communication path. The G1000 system should be
serviced when possible.
serviced when possible.