Q-Logic 8200 Manuale Utente

2–Configuring NIC

NIC TroubleShooting/Diagnostics

SN0054671-00  A

2-51

For every test performed, the diagnostic utility shows the following data:



Total number of attempts 



Number of successful completions 



Number of failures 

You can either perform all tests in succession, or perform only specific tests 
specified by the preceding command-line parameters. 

You can run additional diagnostics in the CLI as listed in the following table. To 
determine the cna_port_inst, issue the qaucli -nic –i command as 

shown in 

.

External Loopback

qaucli -nic -extloopback <cna_port_inst> 
<tests_num> <on_error> 
Where <tests_num> specifies the number of tests, 

1–65535, and <on_error> is either 0=Ignore or 1=Abort.
NOTE: This test requires a pass-through module to be con-
figured for both ports. Test runs between two ports. Single 
port loopback is not supported.

Flash

qaucli –nic –testflash [cna_port_inst]

Hardware

qaucli –nic –testhw [cna_port_inst]

Internal Loopback

qaucli -nic -intloopback <cna_port_inst> 
<tests_num> <on_error>
Where <tests_num> specifies the number of tests, 

1–65535, and <on_error> is either 0=Ignore or 1=Abort.

Interrupt

qaucli –nic –testinterrupt [cna_port_inst]

Link 

qaucli -nic -testlink [cna_port_inst]

Ping (IPv4)

qaucli -nic -ping <cna_port_inst> 
<hostname_or_IPv4> [<count> <pocket_size> 
<timeout_ms> <TTL>]
Where the default values are count=5, 
pocket_size=525, timeout_ms=1000, and 
TTL=30.

Register

qaucli -nic -testregister [cna_port_inst]

Transceiver DMI Data

qaucli -nic -trans [cna_port_inst]