Hitachi 50GX49B Manuale Utente

Pagina di 58
FIRST TIME USE 
- 12 - 
]
 REMOTE CONTROL  Sensor 
Point your remote control at this area when selecting channels, adjusting volume, etc. 
^
DIGITAL ARRAY
  
Use this button to enter Digital Array mode. This will allow you to adjust your picture quality to optimum performance. ( 
See page 37.) 
FIRST TIME USE  
 
Q
 Antenna Input/Output 
The remote control allows you to switch between two separate 75-Ohm RF antenna inputs, ANT A and ANT B. ANT A 
input can be displayed as a main picture or sub-picture. ANT B can only be displayed as a main picture. (ANT B cannot be 
displayed as a sub-picture.) The antenna output labeled "TO CONVERTER" allows the ANT A connection to pass directly 
to a different source such as a cable box, when ANT B is displayed as a main picture. 
R
  Audio/Video Inputs 1, 2 
The INPUT button will step through each video source and antenna source input each time it is pressed.  Use the audio and 
video inputs to connect external devices, such as VCRs, camcorders, laserdisc players, DVD players, etc.  (If you have 
mono sound, insert the audio cable into the left channel jack). 
NOTE:  You may use VIDEO, S-VIDEO, or COMPONENT: Y-CB-CR inputs to connect to Input 2, but note that 
only one of these may be used at a time
S
 Monitor Out 
These jacks provide fixed audio and video signals which are used for recording. To have S-Video output, S-Video signal 
needs to be input to input 1 or input 2. 
T
 Audio to Hi-Fi 
These jacks provide variable audio output to a separate stereo amplifier. With this connection, the audio to the stereo can be 
controlled by the television's main volume. 
 
U
 S-Video Inputs 1 and 2 
Inputs 1 and  2  provides S-Video (Super Video) jacks for connecting equipment with S-Video output capability. 
V
Y-CB-CR Input: 2 (36UX59B and 32UX59B models) 
This input provides Y-CB-CR jacks for connecting equipment with this capability, such as a DVD Player. 
NOTE: DO NOT connect standard VIDEO or S-VIDEO to Input 2 when using Y-CB-CR input. 
 
 When using the Y-CB-CR input jacks, connect your components audio output to the TV's input 2 Left and Right Audio 
input jacks. 
 
Your component outputs may be labeled Y, B-Y, and R-Y. In this case, connect the components B-Y output to the TV's CB