Hitachi 50GX49B Manuale Utente
REAR SPEAKER TERMINAL CONNECTIONS
- 14 -
REAR SPEAKER TERMINAL CONNECTIONS
CONNECT AFTER TURNING THE POWER TO THE TV OFF.
Press the Right Speaker red button and insert the positive (+) lead wire into the hole next to the button. Once the wire is in
place, pull the red button back to original position and the wire is locked into place. In the same manner, press the Right
Speaker black button and insert the negatvie (-) lead wire. Repeat this procedure for the Left Speaker.
place, pull the red button back to original position and the wire is locked into place. In the same manner, press the Right
Speaker black button and insert the negatvie (-) lead wire. Repeat this procedure for the Left Speaker.
CAUTION: Do not short speaker terminal, (do not connect a wire directly across any two terminals). This could
cause damage to your audio outputs or other damage to your TV.
CAUTION: Do not connect speakers simultaneously to the REAR SPEAKER terminal of the Projection TV and
an external amplifier. This could damage both the TV and the speakers. Your TV was designed to use 8-Ohm speakers
only. Any other type may degrade the audio performance of your entertainment system..
only. Any other type may degrade the audio performance of your entertainment system..
TIPS ON REAR PANEL CONNECTIONS
S-Video connections are provided for high performance laserdisc players, VCRs etc., that have this feature. Use these
connections in place of the standard video connection if your device has this feature.
connections in place of the standard video connection if your device has this feature.
If your device has only one audio output (mono sound), connect it to the left audio jack on the TV.
Refer to the operating guide of your other electronic equipment for additional information on connecting your hook-up
cables.
cables.
A single VCR can be used for VCR #1 and VCR #2, but note that a VCR cannot record its own video or line output
(INPUT: 1 in the example on page 11.) Refer to your VCR operating guide for more information on line.
(INPUT: 1 in the example on page 11.) Refer to your VCR operating guide for more information on line.
You may use VIDEO OR COMPONENT: Y-CB-CR inputs to connect to Input 2, but note that only one of these may be
used at a time.
used at a time.
Connect only 1 component to each input jack.
COMPONENT: Y-CBCR connections are provided for high performance components, such as DVD players. Use these
connections in place of the standard video connections if your device has this feature.
connections in place of the standard video connections if your device has this feature.
When using the Y-CBCR input jacks, connect your components audio output to the TV's Input 2 Left and Right Audio
input jacks.
input jacks.