Honeywell T7351 Manuale Utente

63-2666—02

12

a

On: Continuous fan operation during occupied periods. During not occupied periods and in standby mode when no motion is 

sensed, fan cycles with call for heat or cool.

Auto: Fan cycles with call for heat or cool during all periods. (See Product Data Sheet, form 63-2605, for more details).

NOTES: The display returns to default screen after pressing Run Schedule (or after a period of time without keypress):

—

ten seconds: when returning from temporary setpoint changes, info screen, temp occ, and temp not occ.

—

one minute: when returning from setting clock/day.

—

ten minutes: when returning from System Checkout.

—

five minutes: when returning from all other modes.

1. Press both Run Schedule and Clear Start Time.

2. The display gives the option to revert to FAC CFG.

a. To restore the factory defaults, press up

or 

down

until the display indicates YES.

b. To cancel this option, ensure the display 

indicates NO.

3. Press Run Schedule.

Performing this operation reverts the schedules to the factory 

defaults:

1. Press both Info and Clear Start Time.

2. The display gives the option to revert to FAC SCH.

a. To restore the factory schedule, press up

or 

down

until the display indicates YES.

b. To cancel this option, ensure display indicates NO.

3. Press Run Schedule.

The minimum off time for compressors is bypassed 

during Test Mode. Equipment damage can occur if the 

compressor is cycled too quickly.

Use the Test Mode to check the thermostat configurations and 

operation. To start the system test:

1. Press Schedule Day, Occupied and Not Occupied 

simultaneously.

2. The display gives the option to TEST.

a. To enter test mode, press up

or down

until the 

display indicates IN TEST.

b. To cancel this option, ensure display indicates NO 

TEST.

3. Press Run Schedule.

NOTES:

—

To verify whether or not the system test is still 

active, repeat the above process.

—

The system test times out after ten minutes with no 

key pressed.

Save User Schedule (Info/Copy)
Performing this operation saves the current schedule 

(including holidays) to memory, overwriting the old saved 

schedule:

1. Press both Info and Copy.

2. The display gives the option to revert to SAV SHD.

a. To save the current schedule, press up

or 

down

until the display indicates YES.

b. To cancel this option, ensure display indicates NO.

3. Press Run Schedule.

Get User Schedule (Info/Run)
Getting the user schedule restores the schedule (including 

holidays) from saved memory, overwriting the schedule 

currently in use:

1. Press both Run Schedule and Info.

2. The display gives the option to GET SHD.

a. To retrieve the saved schedule, press up

or 

down

until the display indicates YES.

b. To cancel this option, ensure display indicates NO.

3. Press Run Schedule

Upon initial thermostat power-up, a startup and initialization 

program begins. This startup occurs only on initial power-up. 

After total loss of power for an extended period, the current 

time and day can be lost (requiring reset). However, the 

thermostat retains the user program.

NOTE: With no program set, the thermostat controls to the 

Occupied default setpoints of 70° F (21° C) for heat 

and 75° F (24° C) for cool.

Schedule

Fan

Selects fan operation mode. Toggles between On and Auto.

a

Run Schedule

Resumes running schedule (cancels Temporary Occupied action, Holiday, and/or 

Temporary setpoint changes.)