Nortel Networks 1140E Manuale Utente

1.

Check with your administrator to ensure that Bluetooth is available for 
your use.

2.

Restart your IP Phone 1140E using one of the following methods:

•

If you are using an AC power adapter, unplug it, wait 10 seconds, and 
reinsert it.

•

If you are using Power Over Ethernet (POE), unplug the LAN 
Ethernet cable, wait 10 seconds, and reinsert it.

3.

Double-press the  

key 

access 

.

The

 check box is highlighted.

Note: If the 

 item appears dimmed, then your phone 

is not configured to support a Bluetooth headset; contact your system 
administrator.

4.

Press the 

 key to activate Bluetooth.

A check mark is displayed to indicate that Bluetooth is activated. The 
message “BT Enabled” appears at the bottom of the display.

5.

Put your Bluetooth headset in its pairing or search mode. The 
procedure for doing this can be different for each Bluetooth headset. 
Refer to the documentation that accompanied your headset, or 
contact the vendor. 

For example, if you are using the GN Netcom GN 6210, do the 
following:

a.

Turn the headset off by pressing and holding the 

 

button for 3 - 4 seconds until a 

high to low tone is heard. The 

headset blue LED turns off.

b.

Press and hold the 

 button for about 8 seconds until 

the blue LED flashes and then lights steadily.

6.

Search for (pair) the headset:

a.

Press the 

 navigation key one or more times until the 

 button is shown next to the Search Devices item.

b.

Press the 

 key. 

The message "Searching…." is displayed.