Konica Minolta 7013 psc Manuale Utente

 

Hardware Installation-3

 

You can connect your 

 

 network in one of two ways:

1. 

 

. This network connection 

uses a 4-wire RJ cable to plug into the RJ45 network connector on the Print Server 
Card. 

 

Note:

The Print Server Card on power-up automatically determines which type of net-

work connection you are making; 100BaseT, 10BaseT, or 10Base2. However, 

some older 10BaseT hubs may not support auto-detection of 10BaseT versus 

10Base2. If this occurs, you may be required to change a jumper from automatic 

 

to manual selection. See 

 

 for details.

2.

 

. Your Print Server Card may include a BNC 

connector for 10Base2 or Thinnet connection. The Thinnet Ethernet wire uses a 

BNC T-connector to plug into the BNC port on the Print Server Card (marked 

 

 on the bracket). This Ethernet cable is 1/4-inch coaxial cable (usually 

RG-58/U) that uses the cylindrical BNC T-connector to attach to the BNC port.

Once you make the connection, continue to