Konica Minolta kn303ev2 Manuale Utente

2-10  Konica Network Interface Card INSTRUCTION MANUAL

●

The network setup page allows you to check selected options and change specific settings. The following

descriptions explain the function of each item.

When settings are changed the print controller must be restarted to reset (restart) the net-

work interface card.

If the print controller is built in the main body printer, it is necessary to turn OFF/ON the main

body printer.

Resets the network interface card to make newly setup parameters effective but does not reset the

main body printer and the print controller. To reset the main body printer and print controller, turn off

each main power supply, then turn it back on.

Switches all settings on the network interface card back to their factory default (or initial) values. When

operating a printer in a new environment use this feature to clear all setting values except the serial

number and MAC address of the network interface card.

Displays the status of a protocol effective on a selected network interface card. In the uppermost line,

the corresponding protocol (NetWare, TCP/IP or AppleTalk) is displayed whether that protocol is cur-

rently enabled or not. You can change settings using [Setup NetWare], [SetupTCP/IP] and [Setup

AppleTalk] in the protocols group.

Displays the serial number and MAC address of the selected network interface card.

Allows you to set up or change a password. To change the current password, type it in the [Old

Password] Input field, type a new password in the [New Password] Input field, and then type the same

new password in the [Retype New Password] field, for confirmation. Finally, click on [Accept Settings]

to make the new password effective.

For each of the following setup items selected, you can click [Accept Settings] to continue the process,

or you can click on [Clear Inputs] to cancel the setup process.

Keep in mind that a valid password is required after you can enter data or change settings on the

screen. The default password is [sysadm].  To make new settings effective, be sure to reset the network

interface card.