Daewoo dwd-e1211w's Manuale Utente
25
* DRY(DWD-E1211R'S)
Put the laundry into the Drum and close the Door.
Press the Power button.
• The LED shows only '- --' signal.
• The LED shows only '- --' signal.
Select the 'DRY CONDITION' you want by pressing 'DRY' button.
As this button is pressed, the dry condition is selected by 'Cupboard'
As this button is pressed, the dry condition is selected by 'Cupboard'
→
'Very'
→
'Time(30, 1:00, 1:30)'
→
OFF
→
'Low Temp'
→
'Iron'
→
'Cupboard'
Press the 'Start/Pause' button.
• The washer will be operated with locking Door.
• The washer will be operated with locking Door.
1
2
3
4
Note
• Do not use the detergent and softener.
• Cold water tap should be opened.
• After finishing this program,
• Cold water tap should be opened.
• After finishing this program,
is showed on PCB board alternately and the smoothing creases
program is conducted during 30 minute and then power is OFF.
• 'WOOL' and 'DELICATE' and 'BLANKET' program are not select 'DRY'.
• Be careful the high temperature of laundry when put out clothes.
• A little shrikage and deformation will be possibly happened after drying, so check clothes whether dry or not
• Be careful the high temperature of laundry when put out clothes.
• A little shrikage and deformation will be possibly happened after drying, so check clothes whether dry or not
previously
• If the dry performance is poor, change the selecting temperature.
• If youn want to dry with wash, after selecting program, press the 'DRY' button then press 'Start/Pause'
• If youn want to dry with wash, after selecting program, press the 'DRY' button then press 'Start/Pause'
button.