Grizzly h6162 Manuale Utente
MODEL H6162
TRAILER SCREW JACK
2000 LB.
INSTRUCTION SHEET
To reduce the risk of property damage,
serious personal injury, or death when using
this jack, take the following precautions:
•
Refer to your trailer owner's manual to
verify the Trailer Net Weight does not
exceed the maximum trailer jack load
rating of 2000 lbs.
•
During installation, do not place any
part of your body under the trailer
tongue. Only support the trailer tongue
with jack stands rated for more than the
tongue weight of your trailer.
•
Only use this trailer jack on a hard,
level surface capable of sustaining the
load.
•
Always block trailer wheels when using
this trailer jack.
•
Do not modify this trailer jack.
•
Never allow children to play with or near
the trailer jack while it is supporting the
trailer.
•
Never work under a trailer that is
supported only by a trailer jack.
•
Periodically inspect the jack fasteners,
frame, and welds for looseness, cracks,
or other damage. Do not use the jack if
there is a problem.
•
Never tow a trailer with the jack in the
"Down" position, and be sure to lock
the jack in the "Up" position before
towing the trailer.
•
Always make sure that the trailer hitch
receiver is fully connected and properly
locked to the ball hitch before retracting
this trailer jack.
Introduction
The Model H6162 Trailer Screw Jack is designed
to be mounted to the tongue of a trailer with a
tongue weight less than 2000 lbs. The jack has 10
inches of vertical travel, allowing the trailer tongue
to be raised and lowered as needed. The mount-
ing plate allows the jack assembly to swing out of
the way and lock in place when it is not in use for
safer towing.
to be mounted to the tongue of a trailer with a
tongue weight less than 2000 lbs. The jack has 10
inches of vertical travel, allowing the trailer tongue
to be raised and lowered as needed. The mount-
ing plate allows the jack assembly to swing out of
the way and lock in place when it is not in use for
safer towing.
Specifications
Maximum Load ......................................2000 lbs.
Retracted Height (Foot to Pivot Center) ......10
Retracted Height (Foot to Pivot Center) ......10
1
⁄
4
"
Extended Height (Foot to Pivot Center) .....20
1
⁄
4
"
Vertical Travel ................................................ 10"
Mounting Plate Size ..................................4" x 5"
Foot Size ...................................................5" x 7"
Weight .......................................................12 lbs.
Mounting Plate Size ..................................4" x 5"
Foot Size ...................................................5" x 7"
Weight .......................................................12 lbs.
CoPyRigHT © noVEMBER, 2008 By gRizzLy induSTRiaL, inC.
WARNINg: NO PORTION Of THIS MANUAL MAy BE REPRODUCED IN ANy SHAPE
OR fORM WITHOUT THE WRITTEN APPROvAL Of gRIzzLy INDUSTRIAL, INC.
#JB11236 PRinTEd in CHina
figure 1.
Model H6162.