Grizzly h6162 Manuale Utente

1.  Read all required safety precautions listed.

2.  Back the tow vehicle up to the trailer tongue,

then turn the jack handle to lift the trailer as
necessary  to  connect  the  trailer  to  the  tow
vehicle.

3.  Connect  the  trailer  to  the  tow  vehicle  and

turn the jack handle until the jack foot is fully
retracted.

4.  Pull  the  lock  pin,  then  rotate  the  jack

approximately  90°  until  the  lock  pin  snaps
back  into  place,  securing  the  jack  in  the
towing position (

figure 3).

1.  Read all safety precautions listed.

2.  on a level surface, chock the trailer wheels,

raise  the  trailer  tongue  at  least  18"  off  the
ground  with  a  floor  jack  or  other  suitable
lifting device, then use a jack stand to support
the trailer tongue.

3.  identify  a  mounting  location  on  one  of  the

trailer tongue's main frame rails. Be sure that
the  location  is  perpendicular  to  the  ground
(vertical) and will provide adequate clearance
when  connecting  the  trailer  to  the  tow  hitch
of the towing vehicle. also, be sure that the
chosen  location  will  allow  the  jack  to  swing
90° and lock in position when towing.

4.  While wearing safety glasses, use snap ring

pliers  to  remove  the  external  retaining  ring
that  secures  the  mounting  plate  to  the  jack
assembly, then separate them (

figure 2).

 Retaining ring location.

External

Retaining Ring

Mounting Plate

Jack assembly

5.  Prepare the trailer mounting location and the

jack  mounting  plate  for  welding  as  required
by  correct  welding  practices,  then,  wearing
proper  protective  welding  gear,  weld  the
mounting plate to the trailer tongue. if you are
unexperienced  with  welding,  take  the  trailer
and  jack  to  a  professional  welding  shop  for
installation.

6.  once  the  weld  is  fully  cooled,  re-install  the

jack assembly and replace the external retain-
ing ring.

7.  Turn the handle to lift the trailer tongue and

remove the jack stand.

 Rotating the jack.

Lock Pin

5.  Pull on the jack to make sure it is locked in

position.

6.  When  you  are  ready  to  remove  the  trailer

from the tow vehicle, chock the trailer wheels
and  secure  the  parking  brake  on  the  tow
vehicle.

7.  Pull the lock pin and rotate the jack towards

the  support  position  until  the  lock  pin  snaps
back into place.

8.  Release  the  hitch  mechanism  on  the  trailer,

then  turn  the  jack  until  the  tongue  lifts  from
the hitch, then remove the tow vehicle.

Towing

Position

Support

Position