Grizzly t23122 Manuale Utente

1.  read all required safety precautions listed.

2.  Turn the jack handle to lift the trailer tongue

high enough to clear the vehicle tow ball.

3.  Back  up  the  tow  vehicle  so  that  the  trailer

tongue lines up with the tow ball. Shut off the
tow vehicle and apply its parking brake.

4.  Lower the tongue onto the tow ball and lock

them  together.  Connect  safety  chains  and
electrical connections. Fully retract the jack.

5.  Pull  the  lock  pin,  then  rotate  the  jack

approximately  90°  until  the  lock  pin  snaps
back  into  place,  securing  the  jack  in  the
towing position.

1.  read all safety precautions listed.

2.  on a level surface, chock the trailer wheels,

raise  the  trailer  tongue  at  least  18"  off  the

ground  with  a  floor  jack  or  other  suitable

lifting device, then use a jack stand to support

the trailer tongue.

3.  identify  a  mounting  location  on  one  of  the

trailer  tongue's  main  frame  rails  that  meets

the following requirements:

•  is perpendicular to the ground (vertical)

•  Provides  adequate  clearance  when  con-

necting  the  trailer  to  the  tow  hitch  of  the

towing vehicle.

•  allows  the  jack  to  swing  90°  and  lock  in

position when towing.

•  Provides  a  clamping  location  for  all  four

bolts  and  both  clamping  brackets  (see

Figures 2–3).

•  Prevents  the  jack  from  twisting  or  sliding

during use.

6.  Pull on the jack to make sure it is locked in

position.

7.  When  you  are  ready  to  remove  the  trailer

from the tow vehicle, chock the trailer wheels
and  secure  the  parking  brake  on  the  tow
vehicle.

8.  Pull the lock pin and rotate the jack towards

the  support  position  until  the  lock  pin  snaps
back into place.

9.  release  the  hitch  mechanism  on  the  trailer,

then  turn  the  jack  until  the  tongue  lifts  from
the hitch, then remove the tow vehicle.

4.  Mount  the  jack  in  the  chosen  location,  as

shown  in

Figure  3,  using  the  provided

mounting hardware.

—if  your  mounting  position  requires  addi-

tional hardware, make sure you use grade
8 fasteners.

5.  rotate  the  jack  to  the  vertical  position,  then

make  sure  the  lock  pin  is  inserted  fully  into
the mounting plate

6.  Turn the handle to lift the trailer tongue and

remove the jack stand.

2-7/16"

3-7/16"

4-7/16"

5-7/16"

 Mounting plate bolt pattern.

 Typical mounting position.

Mounting Plate

Clamping

Bracket

Mounting

Bolt

Lock Pin