Crestron cnmsx Manuale Utente

Integrated Control System 

Crestron CNMSX

NOTE:  If a computer is not hooked up, wait approximately three to four seconds.  

- 

Release the SW-R button.  

5d.  If the CNMSX responds, proceed to step 5e. Otherwise, do the 

following. 

- 

Remove power from the CNMSX.  

- 

Depress and hold the SW-R button on the CNMSX front panel. 

- 

Reapply power to the CNMSX.  

- 

Wait until a message similar to the one below appears in the 
Viewport.  

 

NOTE:  If a computer is not hooked up, wait approximately three to four seconds.  

- 

Release the SW-R button.  

 

5e.  Text messages, as shown below, should appear on the Incoming 
window of the Viewport. If messages do not appear or they are illegible, 
verify that the Viewport is set to 9600 baud and repeat steps 5a through 
5d. If data similar to that shown below appears, perform steps 7 through 
11 in "Obtaining Communications" on page 24 before proceeding to the 
next step.  

 

NOTE:  The exact text received depends on the given CNMSX hardware.  

•  Integrated Control System:  CNMSX