Crestron cnmsx Manuale Utente

Crestron CNMSX 

Integrated Control System

 

5f.  Remove power from the unit again and reapply power without holding 

the RESET button down. Wait a few seconds and perform step 7 in 
"Obtaining Communications" on page 24. 

NOTE:  If after trying all these procedures, communication cannot be established, 
contact Crestron technical support for assistance. Refer to "Further Inquiries" on page 
36.  

To load the system program into the CNMSX, use the Crestron Viewport or the 
Transfer Program option in SIMPL Windows. For consistency, the steps that follow 
this paragraph use the Viewport. To upload a BIN file into the CNMSX, complete the 
following steps in the order provided.  

1. Select 

Tools | Viewport to open the “Crestron Viewport” dialog box, if 

it is not already opened.  

2. Select 

File Transfer | Send Program (alternatively, depress Alt+P) to 

open the “Cresnet Simpl Program” dialog box.  

3. Use 

the 

Browse button to locate the supplied BIN file.  

4.  As shown after this step, click the Send Program button to initiate 

program upload to the CNMSX. A Transfer in Progress dialog box 
opens, but no response is required. If SIMPL+ files are present and the 
SIMPL+ Program(s) option is checked in the “What to Send” field, the 
associated files will be transferred after the program is transferred. 

 

NOTE:  The permanent memory image is the program stored into flash memory. 
From the image, the program can be recalled automatically if power to the unit is lost 
or interrupted. Permanent memory can be overwritten as many times as needed.  

5.  When a "Query" dialog box opens to create the permanent memory 

image, click Yes. A "Success" dialog box opens when the permanent 
memory image is complete. If the "Failure" dialog box opens, repeat 
steps 3 and 4. If this does not remedy the problem, call Crestron 
technical support. Refer to "Further Inquiries" on page 36. 

•  29