INSTEON 2443-522 Manuale Utente
Page 10 of 21
2443-222/2443-422/2443-522 - Rev: 1/21/2014 8:28 AM
Controller LED will start blinking
You will have four minutes to complete the next steps before linking mode times out
You will have four minutes to complete the next steps before linking mode times out
2) Adjust load connected to Micro module to desired brightness level (even off)
3) Press and hold Micro module Set button until it double-beeps
Controller will double-beep and its LED will stop blinking
4) Test link by tapping controller button on and off
Load connected to Micro module will respond appropriately
Make Micro Module a Responder (Switch)
1) Press and hold controller Set button until it beeps
Controller LED will start blinking
You will have four minutes to complete the next steps before linking mode times out
You will have four minutes to complete the next steps before linking mode times out
2) Adjust load connected to Micro module to desired level (on or off)
3) Quickly tap switch connected to Micro module exactly five times in less than four seconds. (If using a latching or
dual momentary switch, alternate switch directions: up-down-up-down-up or down-up-down-up-down.) After
tapping switch, wait two seconds.
tapping switch, wait two seconds.
Micro module will double-beep
Controller will double-beep and its LED will stop blinking
Controller will double-beep and its LED will stop blinking
4) Test link by tapping controller button on and off
Load connected to Micro module will turn on and off
Make Micro Module a Controller (Set button)
Note: you must perform these steps before reinstalling the wall switch, outlet or fixture.
1) Press and hold Micro module Set button until it beeps
Micro module LED will start blinking green
You will have four minutes to complete the next steps before linking mode times out
You will have four minutes to complete the next steps before linking mode times out
2) Adjust responder to desired state
3) Press and hold responder Set button until it double-beeps
Micro module will double-beep and its LED will stop blinking
4) Test link by tapping or pressing and holding Micro module on/off buttons to turn on/off or brighten/dim
Responder will respond appropriately
Make Micro Module a Controller (Switch)
1) Quickly tap switch connected to Micro module exactly five times in less than four seconds. (If using a latching or
dual momentary switch, alternate switch directions: up-down-up-down-up or down-up-down-up-down.) After
tapping switch, wait two seconds.
tapping switch, wait two seconds.
Micro module will beep to indicate it has entered linking mode
You will have four minutes to complete the next steps before linking mode times out
You will have four minutes to complete the next steps before linking mode times out
2) Adjust responder to desired state
3) Press and hold responder Set button until it double-beeps
Micro module will double-beep and its LED will stop blinking
4) Test link by tapping switch connected to Micro module to turn on/off or brighten/dim
Responder will respond appropriately
1
If responder is a multi-scene device such as a KeypadLinc, tap scene button you wish to control until the LED is in the desired scene state (on or off).
2
If either controller or responder LED continues blinking, the addition failed. Tap device’s Set button until LED stops blinking and try linking again.
3
If responder is a multi-scene device such as a KeypadLinc, tap scene button you wish to control until the LED is in the desired scene state (on or off)