fitnessquest gazelle power plus assembly Manuale Utente

Inc. All rights reserved. Gazelle Power Plus

TM

is a trademark of Fitness Quest

®

Inc.

To familiarize yourself
with the parts, lay them
out on the floor as
shown. Cables should
lay on top of the frames
(be careful you do not
tangle cables with 
swing arms).

Tools Required for Assembly: Phillips Screwdriver

Wrenches (provided)

Occasionally our products contain components that are pre-lubricated at the factory. We recommend that you protect
flooring, or anything else the parts may contact, with newspaper or cloth. 

b. Lying Out Swing Arms
Move the left and right swing arms to the
center of the frame assembly as shown. Make
sure the cables lay on the top of all pieces.

a. Base Frame Assembly
First, remove the 6,  M8 x 25mm bolts and
spring washers on the left and right base
frames marked L and R with the arrows
toward the front. 

Second, use 4 of the M8 x 25mm bolts, 
2 on each end, to attach the cross tube to 
the top of the base frame.

We recommend having someone
available to help you. Due to the
size and weight of some of the
pieces, assembly is easier and safer
if there are two people.

Third, attach the frame plates to each side
of the base frames using (4) M10 x 95mm
hex bolts and spring washers from the 
fastener pack. These bolts also secure the
base frame to the cross tube. Tighten bolts.

remove 6 

M8 x 25mm 

bolts from

left base

replace 2

M8 x 25mm 

bolts to attach

cross tube

replace 2

M8 x 25mm 

bolts to attach

cross tube

remove 6

M8 x 25mm 

bolts from
right base

If you do not wish to use the hydraulics,
remove the clips and move the hydraulics into
the zero resistance slot. Replace both clips.

NOTE: There are 4 levels of resistance on the
unit. Begin exercising at Level 1 (zero resistance)
and slowly advance to the next level when the
current level becomes too easy. The levels
increase as you move the pin towards you to
the next position.

a.

Fasten mounting brackets

to the outside edges of the
left and right foot tubes using
(2) hex bolts, (2) washers and
(2) nylon nuts. Tighten bolts
with wrenches provided.

d.

Pull left hydraulic down to allow pin to pass

through resistance hole in mounting bracket. For
ease of assembly, raise foot platform slightly so
pin can reach mounting bracket.

e. 

Lock clip onto hydraulic pin.

Repeat Steps d and e on 
right side.

b.

Mount left hydraulic to left swing arm using 

(1) spring, (1) M12 washer, (2) rubber pads, 
(1) M12 washer (1) M8 washer, (1) nut, and 
(1) nut cap.
Note: the bottom of
the hydraulic must
have the pin facing
the swing arm.

c.

Mount right hydraulic

to right swing arm using
(1) spring, 
(1) M12 washer, 
(2) rubber pads, 
(1) M12 washer,
(1) M8 washer, 
(1) nut and 
(1) nut cap.
Note: the bottom of
the hydraulic must
have the pin facing
the swing arm.

Repeat on right side.