fitnessquest gazelle power plus assembly Manuale Utente

Determine which
side of your unit
you want the water
bottle (shown on
the left side here). 

Attach the end cap
onto the frame using a M6 x 40mm Phillips bolt in the lower
hole only. Align the water bottle holder on the end cap so the
tab on the back of the holder fits into the bottom hole of the
end cap. Secure the water bottle in place with an M6 x 40mm
Phillips bolt. 

Attach the other end cap with (2) M6 x 40mm Phillips bolts.

Remove the bolts and washers from the handlebars.

Slide the handlebars into swing arms as shown. 

On the front side of the unit, align the holes and insert
bolts with washers. Tighten with the wrench provided.

Step 1: Remove the two small screws from the bottom of the electronics with the screwdriver provided. 

Insert the two “AAA” batteries in the top housing.

Step 2: Attach the bottom housing with the large bolt provided in the bag with the batteries as shown.

Step 3: From the front of the unit, place the top housing onto the bottom housing and replace the two small screws 

you removed in Step 1 as shown.

c. Left Frame/Swing Arm Assembly
Raise the left frame (marked with the L and arrow 
facing the front) and secure it onto the left base frame
using (4) of the M8 x 25mm hex bolts and spring
washers you removed in step a. 

When tightening these bolts, you can use the wrenches
provided in either the fastener pack or the hydraulics
fastener pack – whichever works best for you.

e. Right Frame/Swing Arm Assembly
Raise the right swing arm and slide it onto the
axle tube. Slide the other large washer onto the
axle tube between the right swing arm and the
right frame. Now raise and slide the right frame
(marked with the R and the arrow facing the
front) onto the axle tube. As you did before, 
gently move the axle tube forward and 
backwards until the notch “catches” in place 
while pushing the right frame on.

Secure everything onto the axle tube with the 
M8 x 25mm hex bolt, spring washer and 
washer that is left from your fastener pack.

Slip the right frame onto the base frame 
assembly and secure it using the M8 x 25mm 
hex bolts and spring washers you removed 
in step a. 

d. Axle Tube Assembly
Raise the left swing arm up to the top of the left frame.
Slip the axle tube through the swing arm from the right.
Make sure the arrow on the axle tube is pointing left and
the notch on the end of the axle tube is down. 

IMPORTANT: Slip a large washer onto the axle between
the swing arm and the left frame before inserting the axle
tube into the left frame. 

Slide the axle tube through the left frame. Gently turn the
axle tube back and forth until you feel the notch “catch” in
place. This will tell you that the axle tube is locked into
place. Secure the axle tube with a M8 x 25mm hex bolt,
spring washer and washer from your fastener pack.