Panasonic KXTG7521FX Guida Al Funzionamento
Useful Information
54
Battery recharge
Making/answering calls, intercom
I cannot activate the
eco mode.
eco mode.
L
You cannot set eco mode when you set the repeater
mode “On”. If required, set the repeater mode to
“Off” (page 35).
mode “On”. If required, set the repeater mode to
“Off” (page 35).
I cannot register a
handset to a base unit.
handset to a base unit.
L
The maximum number of base units (4) is already
registered to the handset. Cancel unused base unit
registrations from the handset (page 34).
registered to the handset. Cancel unused base unit
registrations from the handset (page 34).
L
The maximum number of handsets (6) is already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 34).
registered to the base unit. Cancel unused handset
registrations from the base unit (page 34).
L
You entered the wrong PIN. If you forget your PIN,
contact an authorised service centre.
contact an authorised service centre.
Problem
Cause/solution
The handset beeps
and/or ) flashes.
and/or ) flashes.
L
Battery charge is low. Fully charge the batteries (page
10).
10).
I fully charged the
batteries, but
– ) still flashes or
– the operating time
batteries, but
– ) still flashes or
– the operating time
seems to be shorter.
L
Clean the battery ends (S, T) and the charge
contacts with a dry cloth and charge again.
contacts with a dry cloth and charge again.
L
It is time to replace the batteries (page 10).
The handset display is
blank.
blank.
L
The handset is not turned on. Turn the power on (page
15).
15).
Problem
Cause/solution
_
is displayed.
L
The handset is too far from the base unit. Move closer.
L
The base unit’s AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
Reconnect AC adaptor to the base unit.
L
The handset is not registered to the base unit. Register
it (page 33).
it (page 33).
L
Activating one touch eco mode reduces the range of
the base unit in standby mode. If required, turn eco
mode off (page 16).
the base unit in standby mode. If required, turn eco
mode off (page 16).
Problem
Cause/solution
TG7511_7521FX(e).book Page 54 Tuesday, March 9, 2010 3:22 PM