Panasonic KXTG7521FX Guida Al Funzionamento

52

If the unit detects a problem, one of the following messages is shown on the display.

*1 KX-TG7521

Base no power
or
No link to base. 
Reconnect main 
base AC adaptor.

L

The handset has lost communication with the base 
unit. Move closer to the base unit and try again.

L

Unplug the base unit’s AC adaptor to reset the unit. 
Reconnect the adaptor and try again.

L

The handset’s registration may have been cancelled. 
Re-register the handset (page 33).

L

The supplied telephone line cord has not been 
connected yet or not connected properly. Check the 
connections (page 10).

L

Recording was too short. Try again.

L

Phonebook copy failed (page 23). Confirm the other 
handset (the receiver) is in standby mode and try 
again.

L

The receiver’s phonebook memory is full. Erase the 
unnecessary phonebook entries from the other 
handset (the receiver) and try again.

L

You tried to send an SMS message to a phone number 
saved in the phonebook, caller list, or redial list that is 
over 20 digits long.

L

The phonebook memory is full. Erase unnecessary 
entries (page 22).

L

Message memory is full. Erase unnecessary 
messages (page 43, 44).

L

The call barred list memory is full. Erase unnecessary 
entries (page 33).

L

The maximum number of base units (4) is already 
registered to the handset. Cancel unused base unit 
registrations from the handset (page 34).

L

A wrong type of battery such as Alkaline or 
Manganese was inserted. Use only the rechargeable 
Ni-MH batteries noted on page 4, 7.

L

You must subscribe to a Caller ID service. Once you 
receive caller information after subscribing to a Caller 
ID service, this message will not be displayed. 

TG7511_7521FX(e).book  Page 52  Tuesday, March 9, 2010  3:22 PM